Stats message

RFC 2811: Internet Relay Chat: Client Protocol
3.4.4 Stats message


      Command: STATS
   Parameters: [ <query> [ <target> ] ]

   The stats command is used to query statistics of certain server.  If
   <query> parameter is omitted, only the end of stats reply is sent
   back.

   A query may be given for any single letter which is only checked by
   the destination server and is otherwise passed on by intermediate
   servers, ignored and unaltered.

   Wildcards are allowed in the <target> parameter.
   Except for the ones below, the list of valid queries is
   implementation dependent.  The standard queries below SHOULD be
   supported by the server:

            l - returns a list of the server's connections, showing how
                long each connection has been established and the
                traffic over that connection in Kbytes and messages for
                each direction;
            m - returns the usage count for each of commands supported
                by the server; commands for which the usage count is
                zero MAY be omitted;
            o - returns a list of configured privileged users,
                operators;
            u - returns a string showing how long the server has been
                up.

   It is also RECOMMENDED that client and server access configuration be
   published this way.

   Numeric Replies:

           ERR_NOSUCHSERVER
           RPL_STATSLINKINFO                RPL_STATSUPTIME
           RPL_STATSCOMMANDS                RPL_STATSOLINE
           RPL_ENDOFSTATS

   Examples:

   STATS m                         ; Command to check the command usage
                                   for the server you are connected to




prev
next
3.4.4 Stats message

Other Links
